CIRUGIA CARDIOVASCULAR    
Español | English
ISSN: 0210-0576 
e-ISSN: 1698-7624 
 
Subscribers area
Home Editorial Board Journal Contents Subscriptions Contact Us Authors Instructions
     
   
<<< back |
Original Article

Non-compliance Class II treatment via the bi-dimensional technique

2012, Volumen 42, Número 4
B. Giuliano Maino, Paolo Pagin, Giovanna Maino
Especialista en ortodoncia. Universidad de Parma. Parma, Italia
 

Treatment protocols of two-dimensional techniques allow you to treat every type of malocclusion with high-quality results. A crucial point of treatment with conventional methods is the collaboration of the patient, especially in non-extraction cases. The introduction of the use of mini-screws and developing a protocol integrated with the two-dimensional technique (MGBM system) has made it possible to solve this problem while keeping unaltered the quality standard required. The treatment is divided into three phases that extraction cases boil down to two where traditional anchoring systems such as rubber bands and headgears are replaced by mini-screws. The article discusses clinical stages, highlighting the peculiarities of treatment related to the use of TADs.  (Rev Esp Ortod. 2012;42(4):229-239)

 
 
Key words:
Bi-dimensional technique. Bi-dimensional brackets. Vertical slots. Class II non-extraction treatment. Three phases of treatment. TAD. Mini-screws.
 
[Buy article]
 
 
     
Mallorca, 310 - 08037 Barcelona - Spain
Phone: +34 93 207 59 20
Fax: +34 93 457 66 42
  © Permanyer Publications | Made & Powered by IMMA PUIG | Privacy Policy | Legal notice